Foliar Fungicide Use in Sorghum


By Sorghum Checkoff Agronomy Director Brent Bean, Ph.D.

One reason sorghum is a popular crop in the central U.S. is it has fewer foliar disease problems compared to most crops. Dry climates tend to inhibit many of the diseases that can potentially be a problem, but in regions of the U.S. where wet, humid conditions are prevalent, foliar fungicide applications may benefit sorghum farmers.

An excellent study examining the effectiveness of fungicides and their application timing was conducted in Virginia and North Carolina where eight trials were conducted in 2015, 2016 and 2017.

Sorghum yield loss associated anthracnose disease onset and severity (1).

foliar fungicide use

Anthracnose severity and onset of the disease varied with location. Yield was significantly improved with fungicide applications at three locations, RM-16, SF-17 and LW-17, and improved the economic return at six of the eight sites. How early the onset of anthracnose occurred had a greater effect on yield loss than the severity of the disease when rated at the end of the season.

Of the five fungicides tested in this trial, Headline (pyraclostrobin) and Priaxor (pyraclostrobin + fluxapyroxad) provided the best anthracnose control followed by Quadris (azoxystrobin).

 Foliar fungicides should only be applied to sorghum when the onset of foliar disease occurs before flowering and wet, humid weather is anticipated that will cause the disease to flourish. Fungicide should be applied between the boot and early flowering stages.

Another area where fungicides can be beneficial is reducing lodging that can occur prior to harvest. Lodging often occurs when green leaf tissue is lost to foliar diseases causing the plant to cannibalize the stalk to support grain fill. By protecting the leaves, photosynthesis can provide the needed resources for grain fill while maintaining stalk integrity. Anthracnose

Keep in mind that unlike insecticides and herbicides that kill insects and weeds, most fungicides only inhibit the spread of fungi by slowing their growth and reproduction. Growers in regions with environments that are favorable for anthracnose and other foliar diseases should first consider planting resistant hybrids, and then follow with timely fungicide application as needed.

Foliar diseases that are of concern to U.S. growers are:

  1. Anthracnose (Colletortrichum sublineola)
  2. Leaf blight (northern corn leaf blight) (Exserohilum turcicum)
  3. Gray leaf spot (Cercospora sorghi)
  4. Zonate leaf spot (Gloeocercospora sorghi)
  5. Rough leaf spot (Ascochyta sorghina)
  6. Target leaf spot (Bipolaris sorghicola)
  7. Sooty stripe ((Ramulispora sorghi)
  8. Downy mildew (Peronoscherospora sorghi)
  9. Leaf rust (Puccinia purpurea)